To Next Page

To Previous Page

C-6

2. NETWORK

・When you send a Magic Packet™ frame, make sure the standby lamp of the equipment

is on. If you send a Magic Packet™ frame when the power is about to be turned off after

an OS shutdown, the equipment may restart without being turned off or wake on lan

(WOL) may not function at all. (See “2.7.2 Turning on the power using the LAN”.)

・Depending on the status of the network, Magic Packet™ frames can be lost. In order to

avoid this, set up the system so that Magic Packet™ frames can be propagated without

loss. (See “2.7.2 Turning on the power using the LAN”.)

・Even though a network drive may be configured to be reconnected at logon, sometimes

the reconnection may fail. If this happens, log on again or use the net_use command to

establish the connection.

For information about the net use command, see the Windows® help.

・If the settings of the hub and the network adapter do not match, the performance of the

network adapter may be compromised or the network adapter may not work properly. (See

“2.8 Setting Up the LAN Interface”.)

・The electric potential difference between units can generate heat. Therefore, do not use

twisted-pair Ethernet cables (such as category 5 or STP cables) for network connections

other than the ones specified in “5.9.1 Connector specifications (1) Motherboard

(Standard)”.

Hitachi 65 User Manual

Questions and Answers: