Hitachi 65 - Installation Environment

1. GETTING STARTED
1-13
1.6 Installation Environment
1.6.1 Environment
CAUTION
If you keep at high temperature this equipment, do not touch bare hands.
Otherwise you may result burns.
When this equipment is used, it must be used in the following environment.
Table 1-2 Environment
Item
Requirement
Ambient temperature (Operation)
5 to 40℃
Ambient temperature (Storage)
-10 to 60℃
Temperature gradient
±10 K/h or less
Humidity
20 to 80%RH (non-condensing)
Humidity gradient
± 10% RH/h or less
Dust (*1)
No heavy dust
(0.3 mg/m
3
or less (JEITA IT-1004B classB))
Corrosive gas
None
JEITA IT-1004B class A (Temperature 25℃,
Humidity 50% RH)(*2)
Vibration resistance
5.9 m/s
2
(10 Hz, 5 s, except the DVD drive)
Shock resistance
Operation: 19.6 m/s
2
(while not powered on: 98 m/s
2
)
Power voltage
100 to 240 VAC ± 10%
Power frequency
50/60 Hz ± 3 Hz
Power supply noise
2.0 kV (fast transient / burst wave)
Electrostatic noise contact discharge
4 kV (Air: 8 kV)
Insulation resistance
500 VDC, 20 MΩ
Dielectric strength
1.5 kVAC, one minute
Transient power fault
20 ms or less
Altitude
Less than 1000 m
(*1) This equipment cannot be used in the environment where conductive dust or the like is
floating.
(*2) JEITA：Japan Electronics and Information Technology Industries Association
< NOTE >
・ For information about the precautions for the environment, see
“PRECAUTIONS 1. PRECAUTIONS ABOUT THE EQUIPMENT
(5) INSTALLATION ENVIRONMENT”.