To Next Page

To Previous Page

C-12

8. RACK-MOUNTING METAL FITTINGS

・When the equipment is mounted on a rack with rack-mounting metal fittings, do not put

anything on the equipment. In addition, do not put a load (for example, an object) on the

cover of the equipment.

・When you mount the equipment on a rack mount, for safety reasons, we recommend you

use a combination of rack-mounting metal fittings, a shelf board for a rack mount, and

slide rails. (See an 1.6.2 Installation”.)

9. LITHIUM BATTERIES

・This equipment uses a lithium battery. When you dispose of the battery, observe local

laws and regulations whatever applicable.

10. THE OPTICAL MOUSE

・Due to the nature of the optical sensor, an optical mouse may not work on transparent

materials or light-reflecting materials (glass, mirrors, and the like). Avoid using an optical

mouse on those materials or purchase an optical mouse pad available on the market.

・If the optical sensor is smeared with condensation or oil mist, the optical mouse may not

work properly. If you use an optical mouse in an environment subject to those kinds of

smears, take appropriate measures to protect the equipment.

11. BIOS SETTINGS

・When the main power is OFF while the power from the backup battery is not available or

the battery is not connected, the “After AC Power ON” setting is switched to “Auto”.

After pressing the power switch and starting the system, you can configure the “After AC

Power ON” setting but because the power from the backup battery is not available, the

setting is automatically switched back to “Auto” when you disconnect the power cord.

(See “5.6 BIOS Setup”.)

・The purpose of the clock displayed on the BIOS setup menu screen is not to show the

correct time and date but to configure the time and date. Because of this, the date

displayed on the screen does not change when the actual date changes. If the actual date

changes during setup, you must update the date setting. (See “5.6 BIOS Setup”.)

・When the setup menu is used, the clock display may sometimes show a delay. After you

finish the setup menu, make sure you confirm the clock is correct. (See “5.6 BIOS

Setup”.)

Hitachi 65 User Manual

Questions and Answers: