Hitachi 65 - Table 1-4 Power Cord and Plug Identification

1. GETTING STARTED
1-23
Table 1-4 Power Cord and Plug Identification
Input rating
Plug configuration
Reference
standards
Cord and connector
100V - 120V
North America
1 ANSI C73.11
2 NEMA 5-15P
3 IEC 83
125V
North America
1 ANSI C73.11
2 NEMA 5-15P
3 IEC C13
200V - 240V
North America
1 ANSI C73.11
2 NEMA 6-15P
3 IEC 83
Three-wire power cord
with a two-pole three-
terminal grounding-type
connector.
Universal Euro
4 CEE (7)
II, IV, VII
3 IEC 83
UK
5 BS 1365
3 IEC 83
Australia
6 AS C112
220V – 250V
中华人民共和国
7 GB/T 5023.5
GB 1002,
GB 2099.1
GB 17465.1
GB 15934
< NOTE >
• As an option, this equipment offers a cable clamp to be used for attaching the
power cord to the equipment. Use that cable clamp as required.
• If you use a power cord clamp for preventing accidental disconnection, add an
extra length to the power cord around the connector when you secure the cord,
in order to allow the cord to be disconnected in an emergency. Alternatively,
install an emergency circuit breaker at the outlet side.
a
c
23 mm
a=7±0.05 mm
b=7±0.05 mm
c=15.8 mm
b
电源线请务必使用带
接地相的3相插头。