2. OPERATION
2-2
2.2 Starting the Equipment
Follow the procedure below to start the equipment:
1. Connect the plug of the power cord to the outlet.
2. Turn on the power to the display.
3. Turn on the main power switch on the rear of the equipment. The standby lamp (STBY)
will be turned on.
4. Open the protective cover on the right upper part of the front panel and press the power
switch. (See “1.5 Name and Function of Each Part”.)
5. When the power is turned on, the standby lamp (STBY) is turned off and the status lamp
(STATUS) will light. The status lamp turns “red” when the power is turned on and turns
“green” when the OS starts and the equipment is in operation.
6. If you turn on the power for the first time, set up the equipment according to “3.1 Setup
Procedure When You Turn On the Power for the First Time”. (You need to follow this
procedure only once for the first time when you start the equipment after you purchase
the equipment.)
After the above steps are complete, the equipment automatically goes through the startup
process until the sign in screen appears.
For information about how to control the power using the LAN, see “2.7 Controlling the
Power Using the LAN”.
< NOTE >
・When the RAS software is not installed or during the recovery process, the
status lamp does not turn green and stays red.
To Next Page
Loading...
