2.4.1 Installing an Application
Click
Figure 2.4.1 Installation for TM3000 Application
1. Installation of application program Use for installation of TM3000 application. If the
TM3000 precision is installed already, cannot install. Uninstall the TM3000 application first,
and install.
*Installation procedures of an application please refer to [2.2.1 Installing an Application
Program].
*Uninstallation procedures of an application please refer to [2.2.11 Uninstalling an Application
Program].
2. Setup of system files Use for installing the adjustment data of TM3000.
*In the case of not installing the adjustment data , TM3000 application is not start.
*System files are different data every devices such as factory adjustment data. Do not use it
other than serial number device printed by the disk surface. When it is used for a different device,
it is not worked device original performance. In addition, troubles may happen by that.
2 - 69
To Next Page
Loading...
