Hitachi UX2 - Adjusting Pressure

97
5.9. Adjusting Pressure
This section describes how to adjust pressure.
You can adjust pressure only during ink ejection. To adjust pressure, eject ink.
Check pressure before printing.
You can check pressure on the [HOME] screen or [Operation management], the second screen of the
[Setting] screen.
[Home] screen (checking ink pressure) [Operation management] screen (checking ink pressure)
If there is a difference of 0.010 MPa or more between the displayed value and the standard value, adjust
the pressure by turning the pressure adjusting screw with a flat screwdriver so that the difference falls
within ± 0.002 MPa of the standard value.
1
Ink pressure display value
The value within brackets () is a
standard value.
<< [Home] screen >>
<< [Operation management] screen >>