Hitachi UX2 - Head Cleaning + Ink Ejection (S)

136
6.3.6. Head Cleaning + Ink Ejection (S)
● The process from head cleaning to ink ejection is automatically performed using the Cleaning station.
● Switch the unit to the stop state before performing it.
● Head cleaning mode [Eco, Standard, Deep] is possible to change (see "11.1 Setting Head Cleaning Mode
“ of the Instruction Manual)
● The drying time automatically changes depending on the ink type or IJP detection temperature .
Insert the print head into the Cleaning station. (See Steps to in "11.2. Head Cleaning Using
Cleaning station" of the Instruction Manual.)
Press Head Cleaning + Ink Ejection (S) on the [Safe clean station function] screen.
The screen below appears. Press [OK].
1
1
6
2
3
Improving High ink viscosity