Hitachi UX2 - Setting High-Speed Printing; Overview; When Performing High-Speed Printing by 1 to 3 Lines. (Nozzle Diameter: 65ΜM)

157
8.2. Setting high-speed printing
8.2.1. Overview
● Six modes of HM, NM, QM, SM, D1 or D3 can be selected.
By selecting the mode, high quality printing result can be ensured according to the line speed.
● References for each nozzle diameter
Nozzle diameter
References
65μm
Refer to (8.2.2.) and (8.2.3.) below in this section.
8.2.2. When performing high-speed printing by 1 to 3 lines. (Nozzle diameter : 65μm)
①Necessary conditions to perform high-speed print
● When all necessary conditions from Nos. 1 to 7 are satisfied, high-speed print HM, NM, QM, SM, D1 or
D3 mode can be selected.
No.
Item
Conditions
1
Print line
Number of lines of all columns is the same.
(Refer to Table in " Type of high-speed print and number of vertical dots
used" for number of print lines available.)
2
Character size
Character size of all print items is the same.
(Refer to Table in " Type of high-speed print and number of vertical dots
used" for character sizes available.)
3
Line spacing
Line spacing of all columns is the same. However, if Line spacing is set to 3
or more, High-speed printing is NOT available.
4
Barcode
NOT available.
5
Character orientation
0 or 1.
6
Ink drop use rate
1/1
7
Ink drop charge rule
Standard (Single scan or interlaced)
* If high-speed print mode is “D1” or “D3”, it is better to select same Inter-character space setting for
keeping better print quality.
HM mode
NM mode
Remarks
HM mode is equivalent to particle use
percentage of 1/1.
In the 2-line print setting, NM mode is
equivalent to ink drop use percentage
of 1/1.5.
If the line speed remains the same,
print width in the NM mode will widen
by 1.5 times with respect to HM mode.