Hitachi UX2 - Operation Test of Solenoid Valve and Pump

105
5.13. Operation Test of Solenoid Valve and Pump
This section describes how to check the operation of the solenoid valve and pump. If ink is not ejected or
overflows from the gutter, follow the procedure below to check whether the solenoid valve and pump are
operating.
Press Solenoid valve/pump test on the third screen of the [Setting] screen.
[Solenoid valve/pump test] screen
Operation differences depending on states
[Stop] state
Not [Stop] state
Check the operation of the solenoid valve and
pump. (Operate the solenoid valves one by one.)
The operation state is only displayed.
Operation check such as opening/closing the
solenoid valve is not possible.
Press the operation button, and check if the operational sound of the solenoid valve/pump is heard.
The function of each operation button is as follows:
● Open: Opens the solenoid valve.
● Close: Closes the solenoid valve.
● Operated: Operates the pump.
● Stop: Stops the pump.
1
These items appear for using Safe-Clean
Station (Optional parts).
2