Hitachi UX2 - Automatically Returning Administrator Login State to General User Login State

21
3.4. Automatically Returning Administrator Login State to General User
Login State
(1) Overview
This section describes how to automatically return to the general user state if the unit sits idle with the
administrator logged in. If no keystrokes are made for 15 minutes after the administrator logs in, the system
will return to the login state of a selected general user, according to the flow below.
Flow of returning to general user login state
Start
YES
YES
Is [Enable] set for
[Login method]?
NO
Is the default login ID a
general user?
Return to the general user
with the lowest number.
Return to the last logged
in general user.
End
Return to the general user
with the default login ID.
A general user at the top left of the
[Select login user] screen
= A general user with the lowest
number
Is there a general user
logged in after power-on?