Hitachi UX2 Technical Manual

95
5.8. Replacing Recovery Filter
This section describes the procedure for replacing the recovery filter.
NOTE
● Do not perform this operation while ink is being ejected. Doing so may overflow the ink.
● Make sure that the unit is in the stop state.
Remove the inner cover.
Turn the locknut by hand.
Remove the filter case upward.
Install a new filter case and fix it with the lock nut.
1
Recovery filter
2
Locknut
3
Filter case
4

Hitachi UX2 Specifications

General

Brand	Hitachi
Model	UX2
Category	Printer
Language	English