128
6.3.3. Gutter Cleaning (S)
● If the recovery route is dried up or is clogged, performing gutter cleaning (S) using the Cleaning station
allows cleaning of the range from the gutter to the main ink tank.
● You cannot perform this operation during ink ejection. Switch the unit to the stop state before performing
it.
● Continuous gutter cleaning (S) may cause thinning of ink, resulting in printing disturbance. Ink
replacement may be required after the problem is corrected. Limit the number of times that consecutive
gutter cleaning is performed to a maximum of two.
Insert the print head into the Cleaning station. (See Steps to in "11.2. Head Cleaning Using
Cleaning station" of the Instruction Manual.)
Press Gutter Cleaning (S) on the [Safe clean station function] screen.
The screen below appears. Press [OK].