Hitachi UX2 - Connecting to Input;Output (I;O) Terminals

29
4.2.2. Connecting to Input/Output (I/O) Terminals
NOTE
● Check terminal signals for secure wiring.
Incorrect wiring may cause a board failure.
Layout drawing of connectors
[How to use the I/O plug]
(1) Swage method
Applicable cable size: AWG24 to 16 (φ0.5 to 1.3)
Wire covering to be stripped: 8 to 9 mm
● Insert the stripped part of the wire covering into the pin of the I/O plug.
● Tighten the screw on the top of the pin to secure the cable.
Terminal block TB1
(13 pins)
Terminal block TB2
(10 pins)
External communication connector (USB)
External communication
connector (LAN)
Terminal block TB5
(* Optional parts)
(2) Tightening the screw
(1) Inserting
the cable
I/O plug
Flat screwdriver
Thread
Wire covering to be stripped
Cable