Hitachi UX2 - Ink Disposal through Drain Tube from Main Ink Tank

103
5.12. Ink Disposal through Drain Tube from Main Ink Tank
This section describes how to dispose of ink from the main ink tank without screen operations. This process is
required when circulation system control is unavailable due to a fault such as [Main Ink Tank Too Full].
Open the maintenance cover and remove the inner cover.
Remove the drain tube from the fixing part of the inner cover (B).
Tilt the clamp forward and flip the ink filter vertically.
Remove the drain tube from the main ink tank and put it into the beaker.
* Place the beaker at a position lower than that of the main ink tank.
1
2
3
Drain tube
Remove it from
the fixing part.
Inner cover (B)
Clamp
Drain tube
Ink filter piping tube
Ink filter
Drain tube
Ink filter
4
Drain tube
Remove the joint.
Main ink tank
Drain tube
Beaker
How to remove and install the joint of the
recovery tube and the joint of the waste
solution bottle
<Removal> <Installation>
Unlock
Lock