111
(a) Insert the nozzle of the cleaning bottle into the supply port, and pour about 150 mL of makeup into
the ink reservoir.
(b) Press OK.
● Circulation system cleaning starts.
Repeat and .
Dispose of the ink four times and clean the circulation system four times.
Insert the nozzle of the cleaning bottle into the supply port, and pour about 100 mL of makeup into the
ink reservoir.
Install the supply port cap on the ink supply port.
Attach the nozzle rubber seal.
● Attach the nozzle rubber seal between the charge electrode and the nozzle orifice.
● Attach the nozzle rubber seal after washing it with makeup.
● Be careful not to deform the charge electrode when attaching the nozzle rubber seal.
This completes the process prior to long-term shutdown. The circulation system is now refilled with makeup.
Be sure to perform the procedure described in "5.15.2. Process after Long-term Shutdown" for the process after
long-term shutdown.
● If you spill any ink by mistake, wipe it off
neatly and promptly with wiping paper or
something similar.
Do not close the maintenance cover until
you make sure that the portion you have
just wiped is completely dry.
To Next Page
Loading...
