140
■
6 Remove the print head from the Cleaning station and make sure that the area around the nozzle
including the nozzle orifice and the end of the print head is cleaned and the makeup is dried up.
● The ink stain may remain or the head is not dried enough depending on the ink stain level or
operating environment.
● After cleaning, wipe off the print head with wiping paper if it is wet.
● If the print head is stained after cleaning, perform head cleaning again or clean the print head
using a cleaning bottle.
● If the ink does not come off easily, wipe it off with wiping paper soaked in makeup.
● Do not apply excessive force to the electrode when wiping. Otherwise, the print head may
deform, causing an unexpected malfunction.
■
7 Remove the cleaning solvent container from the Cleaning station and dispose of the makeup in the bottle.
(See Steps to in "11.2. Head Cleaning Using Cleaning station" of the Instruction Manual.)
To Next Page
Loading...
