9
(b) 45 to 50ºC
(i) Install the end of the print head within a range of 1.5 m above the installation surface of the printer.
(ii) Do not install the end of the print head below the installation surface of the printer.
Installation position of end of print head (for 45 to 50ºC)
(10) When using the printer for upward and lateral printing, make sure that the length of raising the print head
cable from the print head is within a range of 0.5 m.
Length of raising print head cable
(11) The minimum bend radius of the print head cable must be at least 150 mm.
NOTE: If the head cable is installed at a bend radius smaller than its minimum bend radius of 150
mm, the wiring and piping inside the cable may be broken or damaged.
(12) The ink stream may bend for some reasons (such as dust). If a facility is placed in the ejection direction that
may cause an ink attachment problem, partially install a cover on the facility.
To Next Page
Loading...
