Hitachi UX2 - 4.2. Start Operation

41
● SW1 setting (for dedicated power supply 12 V)
● SW1 setting (for dedicated power supply 24 V)
* This setting does not depend on the open collector output and totem pole output.
4.3.2.2. Setting to IJ printer
Make the [Product speed matching] and [Pulse rate div. Factor] settings on the [Print specifications] screen
(See "5.6. Setting Print Specifications" in the Instruction Manual.)
● Set [Product speed matching] to [1：Enable].
– Set [Pulse rate div. Factor] if necessary. This function lowers the frequency of the input pulse (makes its
period longer) inside the IJ Printer. Divided pulses are used for printing as shown below.
Description of pulse division function
– The relationship among the rotary encoder signal pulse frequency, print scan frequency, and division
factor is shown in the formula 1.
ON
ON
1 2 3 4 5 6 7 8
OFF
ON
ON
1 2 3 4 5 6 7 8
OFF