Hitachi UX2 - Chapter 5. Creation and Setting of Print Messages

59
● The Character width on the "Print specifications" is automatically set as below depending on the Ink drop use.
Character width set value
4.3.5-4 Carrying speed
● Set the minimum speed the target print is carried by conveyer to 1m/min.
● If the carrying speed the IJ printer detects is faster than the speed of when the printed without Speed matching, print is
made with the same interval as when the Speed matching function is not used. (At the time speed exceeds the limit
speed in the condition)
● If "Print Target width" or "Actual Print width" on the "Print specifications" is not entered, the print is made with the
same interval as when the Speed matching function is not used.
Ink drop use
[Character width]
setting value
1/1
002
1/2
001
1/3 to 1/16
000
Large
Small