Honeywell C300 User Manual

5. C300 Configuration Form Reference
5.1. C300 Controller Block
90
Series 8 C300 Controller User's Guide
Honeywell
R500
April 2017
Plain Text
Parameter Name
User
Configurable
Notes
Disable Battery
Alarm and Soft Fail
DISABLEBATTERYALA
RM
Project only
Allows you to enable or
disable the battery-related
soft failures and events to
be reported.
When this parameter is
checked, battery-related
soft failures and events
are not reported when a
battery is not connected.
When this parameter is
unchecked, battery-related
soft failures and events
are reported.
GPS Time Source
Enabled
GPSENABLE
(Currently not used)
Yes
Allows you to select GPS
as TIMESOURCE for time
synchronization.
Temperature High
Alarm (degC)
OVERTEMPTHLD
Yes
Set threshold value for
module's temperature high
alarm.
CPU Free Low Alarm
(%)
CPULOLM
Yes
Allows user to set CPU
Free Low Capacity alarm
limit in percent.
CPU Free Low Low
Alarm (%)
CPULOLOLM
No
Fixed CPU Free Low Low
Capacity alarm limit in
percent.
Simulation Node Configuration
Load to simulation
Environment
SIMTARGET
Yes
Enables load to simulation
environment.
Host IP Address
HOSTIPPRI
No
Indicates the IP address
for the node hosting the
simulation program.
Host Name
HOSTNAMEPRI
No
Specifies the network
name for the node hosting
the simulation program.
Simulation Node Operation

Honeywell C300 Specifications

General

Memory	512 MB RAM, 512 MB Flash
Type	Process Controller
Communication Ports	Ethernet, Serial
Power Supply	24V DC
Inputs	Analog and Digital
Outputs	Analog and Digital
Communication	Ethernet, Serial, HART
Redundancy	Supported (Hot Standby)