GX-Series Control Panel Installation and Setup Guide
6-31
NOTE: Parameter 51.41 = Weekend Work must be enabled (default is Disabled) to allow the Weekend
Day to be selected by the user.
2 = Pattern Day
Option not available. See Option 65.1.6
2 = Assign groups
This option assigns the groups that will be unset (disarmed) at the weekend.
NOTE: The GX-520 panels have 32 groups; these are displayed on the keypad in block of eight groups, sub-
divided into A, B, C and D. Press the A> or <B key to display each of the group blocks.
45.7 = Access Template
An access template defines when and where a user is allowed access. For each access template, a schedule is
given to each group (area) to define when access to each group is possible. Up to 100 templates are available
per system. There are two options for each template:
1 = Name
A name of up to 12 characters can be allocated to each template.
2 = Schedules
The schedules programmed in Menu option 65, Timers, are allocated to each group with the selected
access template under this option. Group mode has to be enabled in menu option 63.1 to allocate a
weekly schedule to a group.
To Next Page
Loading...
Need help?
General
