Function Parameter Reference Guide
12/00 UDC2300 Controller Product Manual 123
12.2.11 AxSxEV (ALARMx SETPOINTx EVENT - X = 1 OR 2)
This prompt is part of the Alarms Set up group.
Select whether you want the alarm type chosen in prompt AxSxTY to alarm the
beginning or end of a segment in setpoint Ramp/Soak programming.
ATTENTION
Select if Setpoint Programming is enabled and if the Alarm Type is configured for Event On/Off.
Alarms configured for events will not operate on Setpoint Program segments of zero length.
Selections Definitions
BEGN
Beginning of Segment
END
End of Segment
12.2.12 AxSxHL (ALARMx SETPOINTx STATE - X = 1 OR 2)
This prompt is part of the Alarms Set up group.
Select whether you want the alarm type chosen in prompt AxSxTY to alarm High or Low
.
ATTENTION
Select if Setpoint Programming is disabled or if the Alarm Type is not configured for Event
On/Off.
Selections Definitions
HIGH
High Alarm
LOW
Low Alarm
To Next Page
Loading...
