Honeywell UDC2300 - Page 135

Function Parameter Reference Guide
12/00 UDC2300 Controller Product Manual 125
12.2.14 AxSxVA (ALARMx SETPOINTx VALUE - X = 1 OR 2)
This prompt is part of the Alarms Set up group.
This is the value at which you want the alarm type chosen in Prompt “AxSxTY” to
actuate. The value depends on what the alarm setpoint has been configured to represent.
For SP Programming, the value is the segment number for which the event applies.
For PV Rate of Change, the value is the amount of PV rate of change in one minute in
engineering units.
This prompt does not appear for “Alarm on Manual” type alarm (i.e., AxSxTY is set to
MAN).
Range of Setting: within the range of the selected parameter or
of the PV Span for Deviation configurations.
12.2.15 BAUD (BAUD RATE)
This prompt is part of the Communications Set up group.
BAUD RATE is the transmission speed in bits per second.
Selections Definitions
2400
2400 BAUD
4800
4800 BAUD
9600
9600 BAUD
19200
19200 BAUD
12.2.16 BIAS 1 (INPUT 1 BIAS)
This prompt is part of the Input 1 Set up group.
Bias is used to compensate the input for drift of an input value due to deterioration of a
sensor, or some other cause. Select the bias value you want on Input 1.
Range of Setting: –999 to 9999
12.2.17 BIAS 2 (INPUT 2 BIAS)
This prompt is part of the Input2 Set up group.
Bias is used to compensate the input for drift of an input value due to deterioration of a
sensor, or some other cause. Select the bias value you want on Input 2.
Range of Setting: –999 to 9999