Hardware options installation 86
7.
If you are installing the P440 controller for a two-bay SFF hot-plug rear drive cage that is connected
to the front drive cage 2 backplane, disconnect the preinstalled Mini-SAS x4 cable from the two-bay
SFF rear drive backplane.
8. If you are installing the P440 controller for a two-bay SFF hot-plug rear drive cage that is connected
to the system board, disconnect the multiconnector drive signal cable:
a. Open the cable management holder (on page 32).
b. Disconnect the multiconnector drive signal cable from the rear drive backplane and from the
system board.
c. Close the cable management holder (on page 34).
To Next Page
Loading...
Need help?
General