6. Align the PCI card keyway with the slot key, and then firmly seat the card in the slot as shown in
the following figure
.
Figure 5-81 Installing a PCI card
7. Close the PCI retention clamp by rotating it downward
2
.
NOTE: It is normal for the expansion card retention clamp to have a slight (5-10 degree) angle
when closed. If the angle is greater than this, open the clamp and ensure that all cards are properly
seated and all the brackets are mated to the chassis, then re-close the clamp.
138 Chapter 5 Replacing components ENWW
To Next Page
Loading...
