HPE FlexNetwork 5130 EI Series Fundamentals Configuration Guide

28
• Configure login authentication methods in ISP domain view.
• To use remote authentication, configure the scheme to be used.
• To use local authentication, configure a local user and the relevant attributes.
For more information, see Security Configuration Guide.
The next time you Telnet to the CLI, you must provide the configured login username and password,
as shown in the following example:
******************************************************************************
* Copyright (c) 2010-2016 Hewlett Packard Enterprise Development LP *
* Without the owner's prior written consent, *
* no decompiling or reverse-engineering shall be allowed. *
******************************************************************************
login: admin
Password:
<sysname>
If the maximum number of login users has been reached, your login attempt fails and the message
"All lines are used, please try later!" appears.
Setting the maximum number of concurrent Telnet users
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Set the maximum number
of concurrent Telnet
users.
aaa session-limit
telnet
max-sessions
By default, the maximum number of concurrent
Telnet users is 32.
Changing this setting does not affect online
users. If the current number of online Telnet
users is equal to or greater than the new
setting, no additional Telnet users can log in
until online users log out.
For more information about this command, see
Security Command Reference.
Setting the DSCP value for outgoing Telnet packets
The DSCP value is carried in the ToS/Traffic class field of an IP or IPv6 packet, and it indicates the
transmission priority of the packet.
To set the DSCP value for outgoing Telnet packets:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Set the DSCP value
for outgoing Telnet
packets.
• For a Telnet server running IPv4:
telnet server dscp dscp-value
• For a Telnet server running IPv6:
telnet server ipv6 dscp
dscp-value
By default, the DSCP value is 48.
Configuring common VTY line settings
For a VTY line, you can specify a command that is to be automatically executed when a user logs in.
After executing the specified command, the system automatically disconnects the Telnet session.
Before you configure this feature and save the configuration, make sure you can access the CLI
through a different user line.

HPE FlexNetwork 5130 EI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5130 EI Series
Category	Switch
Language	English