To replace the component, reverse the removal procedure.
Removing and replacing the hard drive backplane
Procedure
1. Power off the server (Powering off the server).
2. Extend or remove the server from the rack (Removing the server from the rack on page 139 or
Extending the server from the rack).
3. Remove the access panel (Removing the access panel).
4. Remove all hot-plug hard drives (Removing and replacing a hot-plug SAS hard drive).
5. Disconnect the SAS cable from the hard drive backplane.
6. Remove the hard drive backplane.
152 Removing and replacing the hard drive backplane