IMPORTANT:
After changing the mode, perform a reconnect -r command at UEFI.
NOTE:
Commands are not case-sensitive.
Updating the firmware using saupdate
Procedure
1. Download the firmware image file into the system UEFI partition.
2. Boot the system to the UEFI Shell and change directories to the UEFI partition.
3. Use the saupdate list to display all detected Smart Array controllers along with the active firmware
versions, the identification information from this list is used to designate which controller is to be
updated.
4. Use saupdate update <seg:bus:dev:func:index> <firmware image> to update the
firmware.
5. Restart the system.
To query the current mode of the controller usesaupdate get_mode <controller>. The <controller>
could be any one of the strings:
• <seg:bus:dev:func>
A controller having the PCI segment id, bus id, device id and function id is addressed
• all
Updating the firmware using saupdate 183
To Next Page
Loading...
Need help?
General