9. Tie wrap the processor cable to the right tie point on the processor assembly.
CAUTION:
When the processor is installed, dress all slack in the power cable to the connector end of the
cable. Failure to do so can result in pinched or damaged processor power cables.
NOTE:
If you are adding an additional processor to your server, the DIMMs in the server must be
reconfigured to support both processors. For more information, see Memory configurations on
page 64.
HPE Trusted Platform Module (TPM)
The TPM is not a customer-serviceable part.
HPE Trusted Platform Module (TPM) 75
To Next Page
Loading...
Need help?
General