6. If removed, install the air bale.
7.
Install the access panel.
8.
Install the server into the rack.
9.
Connect all peripheral cables to the server.
10.
Connect each power cord to the server.
11.
Connect each power cord to the power source.
12.
Power up the server.
13.
If removed, install the bezel.
System battery replacement
System battery information
The server contains an internal lithium manganese dioxide, a vanadium pentoxide, or an alkaline battery that provides
power to the real-time clock. If this battery is not properly handled, a risk of the fire and burns exists. To reduce the risk of
personal injury:
• Do not attempt to recharge the battery.
• Do not expose the battery to temperatures higher than 60°C (140°F).
• Do not expose the battery to extremely low air pressure as it might lead to explosion or leakage of flammable liquid or
gas.
• Do not disassemble, crush, puncture, short external contacts, or dispose the battery in fire or water.
• If the server no longer automatically displays the correct date and time, then replace the battery that provides power
to the real-time clock. Under normal use, battery life is 5 to 10 years.
Removal and replacement procedures
102
To Next Page
Loading...
