To replace the component, reverse the removal procedure.
Removing and replacing a heatsink
Removing a heatsink
This procedure shows a standard heatsink as an example. The removal process is the same for both the standard and high
performance heatsinks.
Prerequisites
Before you perform this procedure, make sure that you have a T-20 Torx screwdriver available.
Procedure
1.
Observe the following alerts.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system
components to cool before touching them.
CAUTION: THE CONTACTS ARE VERY FRAGILE AND EASILY DAMAGED. To avoid damage to the socket
or processor, do not touch the contacts.
2.
If installed, remove the bezel.
3. Power down the server.
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Disconnect all peripheral cables from the server.
6.
Remove the server from the rack.
7. Remove the access panel.
8. If installed,
remove the air bale.
Removal and replacement procedures
94
To Next Page
Loading...
