a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack.
6. Remove the access panel.
7. Remove the low-profile riser blank.
To replace the component, reverse the removal procedure.
Removing and replacing a riser board
Prerequisites
If replacing the primary riser board, make sure that you have a T-15 Torx screwdriver available.
Procedure
1.
If installed,
remove the bezel.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5.
Remove the server from the rack.
6. Remove the access panel.
7. If present, disconnect all cables from the expansion board.
Removal and replacement procedures
72
To Next Page
Loading...
