To replace the component, reverse the removal procedure.
Removing and replacing the optical drive blank
Prerequisites
Before you perform this procedure, make sure that you have T-10 Torx screwdriver available.
Procedure
1.
If installed,
remove the bezel.
2.
Power down the server.
3.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
4.
Disconnect all peripheral cables from the server.
5.
Remove the server from the rack.
6. Remove the access panel.
7. Remove the optical drive blank:
• LFF
a. Remove the outer drive cage cover.
b. Remove the optical drive blank.
Removal and replacement procedures
76
To Next Page
Loading...
