b. Remove all screws from the system board.
25.
Remove the right OCP NIC 3.0 adapter rail.
26.
Remove the handle from the system board.
Replacing the system board
Prerequisites
Before you perform this procedure, make sure that you have the following items available:
• T-15 screwdriver (for system board screws and the handle)
• T-20 screwdriver (for processor and heatsink screws)
• Thermal grease (spare part number: 777298-001)
• Hex nut screw driver
Procedure
1.
Install the right OCP rail:
a. Remove the VGA screws.
Removal and replacement procedures
109
To Next Page
Loading...
