HPE ProLiant DL325 Gen10 Plus

a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack.
6. Remove the access panel.
7. If installed, disconnect all cables from the expansion boards and remove the expansion boards.
8. Remove the riser cage.
• Primary riser cage
• Secondary riser cage
Installing the air bale
Procedure
1. Observe the following alert.
CAUTION: For proper cooling, do not operate the server without the access panel,
bales, expansion slot
covers, or blanks installed. If the server supports hot-plug components, minimize the amount of time the access
panel is open.
2. Install the air bale.
Removal and replacement procedures
46