Removing and replacing the LFF front I/O assembly
Prerequisites
Before you perform this procedure, make sure that you have the T-10 screwdriver available.
Procedure
1. If installed, remove the bezel.
2.
Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack.
6.
Remove the inner rack rails.
7.
Remove the access panel.
8.
Disconnect the front I/O cable from the system board.
9.
Do one of the following:
• Remove the inner drive cage
• Remove the inner drive cage blank.
10. Remove the outer cage top cover.
11. Release the front I/O cable from the clips.
12. Remove the front I/O assembly.
Removal and replacement procedures
82
To Next Page
Loading...
