11. Install the server into the rack.
12. Connect all peripheral cables to the server.
13. Connect each power cord to the server.
14. Connect each power cord to the power source.
15. Power up the server.
16. If removed, install the bezel.
17. Properly dispose of the old battery.
For more information about battery replacement or proper disposal, contact an authorized reseller or support
specialist.
Removing and replacing a DIMM
Procedure
1. If installed,
remove the bezel.
2.
Power down the server.
3.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
4.
Disconnect all peripheral cables from the server.
5.
Remove the server from the rack.
6.
Remove the access panel.
7.
Remove the DIMM.
To replace the component, reverse the removal procedure.
Removal and replacement procedures
104
To Next Page
Loading...
