To replace the component, reverse the removal procedure.
Removing and replacing the energy pack holder
Procedure
1.
If installed,
remove the bezel.
2.
Power down the server.
3.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
4.
Disconnect all peripheral cables from the server.
5.
Remove the server from the rack.
6.
Remove the access panel.
7.
Lift and slide the energy pack holder to disengage it from the notch and then remove it.
Removal and replacement procedures
75
To Next Page
Loading...
