HPE ProLiant DL325 Gen10 Plus

8. If installed, remove expansion board from the secondary riser cage.
9. Remove the riser cage.
10. If installed, remove all expansion boards from the primary riser board.
11. Remove the riser board.
• Primary riser board
• Secondary riser board
To replace the component, reverse the removal procedure.
Removing and replacing the Smart Array type-a modular controller
or 1-port NVMe adapter
Procedure
1.
If installed, remove the bezel.
2.
Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5.
Remove the server from the rack.
6.
Remove the access panel.
Removal and replacement procedures
73