Replacing a processor
Hewlett Packard Enterprise recommends identifying the processor and socket components before performing this
procedure.
Prerequisites
Before you perform this procedure, make sure that you have the following items available:
• The components included with the hardware option kit
• T-20 Torx screwdriver
• Thermal grease (spare part number: 777298-001)
Procedure
1.
Observe the following alerts.
CAUTION: To avoid damage to the processor or system board, only authorized personnel should attempt to
replace or install the processor in this server.
CAUTION: If installing a processor with a faster speed, update the system ROM before installing the
processor.
To download firmware and view installation instructions, see the Hewlett Packard Enterprise Support
Center website.
CAUTION: THE CONTACTS ARE VERY FRAGILE AND EASILY DAMAGED. To avoid damage to the socket
or processor, do not touch the contacts.
2. Install the spare processor:
a. Hold the processor by its carrier handle and slide the processor into the rail frame until it engages with a click
sound.
b. Hold the lift tabs near the front end of the rail frame and pivot the rail frame to the closed position.
Removal and replacement procedures
99
To Next Page
Loading...
