Removing and replacing the system battery
Procedure
1. If installed, remove the bezel.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5.
Remove the server from the rack.
6. Remove the access panel.
7. Locate the battery on the system board.
8. Remove the battery.
9.
Insert the battery with the "+" side facing up on the socket, and then press the battery down to secure it in place.
10. Install the access panel.
Removal and replacement procedures
103
To Next Page
Loading...
