To replace the component, reverse the removal procedure.
Drive backplanes
Removing and replacing the 4LFF SAS/SATA drive backplane
Prerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
Procedure
1.
If installed,
remove the bezel.
2.
Power down the server.
3.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
4.
Disconnect all peripheral cables from the server.
5.
Remove the server from the rack.
6.
Remove the inner rack rails.
7. Remove the access panel.
8.
Remove all drives connected to the drive backplane.
9. Disconnect all drive backplane cables to system board, controller card, or riser.
10. Do one of the following:
• To replace the drive backplane of the outer drive cage (box 1):
Removal and replacement procedures
62
To Next Page
Loading...
