HPE ProLiant DL325 Gen10 Plus

WARNING: To reduce the risk of personal injury or damage to the equipment, adequately stabilize the rack before
extending a component outside the rack. Extend only one component at a time. A rack may become unstable if
more than one component is extended.
WARNING: When installing a server in a telco rack, be sure that the rack frame is adequately secured at the top and
bottom to the building structure.
Preparation procedures
To access some components and perform certain service procedures, you must perform one or more of the following
procedures:
Procedure
• If installed, remove the bezel.
•
Power down the server.
• Access the product rear panel.
• Extend the server from the rack.
•
Remove the server from the rack.
• Remove the access panel.
•
Remove the air bale.
Removing the bezel
Procedure
1.
Remove the Kensington security lock.
2.
Remove the bezel.
a.
Press the latch.
b.
Open the bezel.
c.
Detach the bezel from the latch ear.
Removal and replacement procedures
33