To replace the component, reverse the removal procedure.
Removing and replacing an M.2 SSD
This procedure is for drives on the system board, riser, or expansion card.
NOTE: Do not perform this procedure on uFF drives.
Prerequisites
Before you perform this procedure, make sure that you have the following items available:
• Philips No. 1 screwdriver
• T-10 Torx screwdriver
Procedure
1. If installed,
remove the bezel.
2. Power down the server.
3.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
4.
Disconnect all peripheral cables from the server.
5.
Remove the server from the rack.
6.
Remove the access panel.
7.
Disconnect the SATA cables from the M.2 SSD enablement board.
8.
Remove the riser cage.
9.
Remove the M.2 SSD enablement board.
10.
Remove the M.2 SSD.
Removal and replacement procedures
61
To Next Page
Loading...
