3. Connect peripheral devices to the server.
For information on identifying connectors, see Rear panel components.
4.
Connect the power cord to the rear of the server.
5.
Secure the power cord in the cable management arm.
6.
Connect the power cord to the power source.
Powering up the server
Procedure
1.
Remove the bezel.
2.
Use one of the following methods to power up the server:
• Press the Power On/Standby button.
• Use the virtual power button through iLO.
3.
Install the bezel.
Installing the bezel
Procedure
1. Install the bezel.
a. Attach the bezel to the latch ear.
b. Press the latch.
c. Close the bezel.
Removal and replacement procedures
50
To Next Page
Loading...
