Installing the server into the rack
WARNING: This server is heavy. To reduce the risk of personal injury or damage to the equipment:
• Observe local occupational health and safety requirements and guidelines for manual material handling.
• Get help to lift and stabilize the product during installation or removal, especially when the product is not
fastened to the rails. Hewlett Packard Enterprise recommends that a minimum of two people are required for all
rack server installations. A third person may be required to help align the server if the server is installed higher
than chest level.
• Use caution when installing the server in or removing the server from the rack; it is unstable when not fastened
to the rails.
CAUTION: Always plan the rack installation so that the heaviest item is on the bottom of the rack. Install the
heaviest item first, and continue to populate the rack from the bottom to the top.
Procedure
1. Install the rack rail option.
For more information, see Installation Instructions on the Hewlett Packard Enterprise website.
2.
Install the server into the rack:
a.
Align the inner rails of the server with the outer rails.
b.
Slide the server into the rack until the quick-release latches engage with the front columns of the rack.
c. Open the latches and tighten the shipping screws, if necessary.
Removal and replacement procedures
49
To Next Page
Loading...
