• Inner drive cage
a. Remove the bracket screw from the cage.
NOTE: The screw is on the top side of the cage.
b. Slide the bracket away from the backplane.
c. Slide and pull out the backplane.
To replace the component, reverse the removal procedure.
Removing and replacing an expansion board
Prerequisites
Before you perform this procedure, make sure that you have T-15 Torx screwdriver available.
Procedure
1. If installed, remove the bezel.
2.
Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
Removal and replacement procedures
67
To Next Page
Loading...
