• SFF Smart Carrier NVMe (SCN)
To replace the component, reverse the removal procedure.
Removing and replacing a uFF drive
Procedure
1.
Back up all server data.
2.
To remove a drive in outer drive cage,
remove the bezel if installed.
3.
To remove the drive from an inner drive cage, do the following:
NOTE: If the HPE designated cable management arm is not installed on the rack, ensure that the cables at the rear of
the server are not damaged while extending the server.
a. Extend the server from the rack.
b. To open the inner drive cage, press the cage latches.
The drive cage pops out of the chassis in the slanting position.
Removal and replacement procedures
59
To Next Page
Loading...
