3. To remove the hot-plug drive from an inner drive cage, do the following:
NOTE: If the HPE designated cable management arm is not installed on the rack, ensure that the cables at the rear of
the server are not damaged while extending the server.
a. Extend the server from the rack.
b. To open the inner drive cage, press the cage latches.
The drive cage pops out of the chassis in the slanting position.
4.
Observe theLED status of the drive and determine if it can be removed.
5.
Remove the hot-plug drive.
• LFF
• SFF Smart Carrier (SC) SAS/SATA/NVMe
Removal and replacement procedures
58
To Next Page
Loading...
